House of matches does not require almost nothing, “except for manual dexterity,” a little bit of diligence and a few hours of free time. You will need: 6-7 boxes of matches, a button or a coin (penny 3 Soviet-era Russian ruble or 2 or 50 KZT, or any other money diameter of about 24 mm), a book or a floppy disk or CD-ROM from krobka (Stand assembly).
1. Put on book 2 matches in parallel to each other at a distance slightly less than the length of a match. sizes.
2. The top 8 matches lay perpendicular to the first two. Moreover, the extreme match should form a square with 2 matches of the 1st series, and between all the other matches to be about the same short distance.
3. The next series of 8 more matches. Place them perpendicular to the previous 8 also with a small distance therebetween.
4. Gently make “well” of a 7-series, having a head matches a circle.
5. On top of the deck do 8 matches. Put their heads in the direction opposite to the heads of matches of the lower deck.
6. Perpendicular to place the next previous row – from 6 matches (2 more extreme add later). Top press resulting construct coin.
7. Hold coin finger to slide vertically in the corners of the house match head upward. Matches must pass between the upper and lower decks, and their edges – get out from the bottom. Matches the lower decks, you can push the other match or toothpick, just make sure that the house is not moved out of the bottom of matches.
8.Poluchilsya house on legs. Plug matches the perimeter along the wall, covering the auxiliary pushing match or toothpick and pressing a finger structure.
9. Squeeze the house wall with 4 sides, pododvinuv stuck to them vertically matches. Remove the coin match.
10. Take the house together and crimp the co all sides.
11. Press the matches that were on the perimeter, so that they pressed heads flooring. The resulting square of the heads of matches – and is the foundation of the house. Those. that was the height of the bottom was. Putting on his house, get the frame sticking out in different directions meet matches. They are needed for the construction of the walls and roof of the house.
12. Please complete the wall. To this paste match heads vertically up co vcex 4 sides.
13 should be put on one more – now horizontal layer walls. In this case, the match should go in a circle, as in the construction of the well, a head – alternating with the ends of matches. Inserting all horizontal match, push their heads that they pressed matches the adjacent walls.
14. Now move on to the roof. First, insert the missing matches in the corner of the hole and tucking vertical walls matches the bottom, pull them up.
15. Lay the roof matches perpendicular to the upper deck, starting from the edges and alternating directions of matches.
16. The first stack 2, then 4, 6 and 2-x central to 8.
17. Between the protruding vertically matches carefully insert the match – “shingles” heads towards the middle. After that push them around head side matches, pressing on them with your fingers.
18. In conclusion, you can decorate the house “pipe” of 4 inserted into the roof of matches, “door” and “windows” of the matches, the broken in half and inserted into the walls.
According to this principle, you can build castles and churches of all sizes.